harryS's latest activity
-
harryS replied to the thread Crazy Walmart mid drive deal $349.I'm not in a select location, too far from the warehouse.. Everytime I look, the $349 grey bike is out of stock. The white one has... -
harryS replied to the thread What camera do you use if you are into photography, when cycling.Had a tire blow out at 6:46 AM on I-90 in West side of Chicago. Pulled off into a sketchy part of town. Hadn't changed a tire in 15...
-
-
harryS replied to the thread What camera do you use if you are into photography, when cycling.I'm going on a ride tomorrow on a pavement ride thru CHicago with maybe 8000 other cyclists. My last time with this event was before...
-
harryS replied to the thread Raleigh Array issue....🤔.It turns on the first time you install the battery, Then it can't turn on until you re-install the battery. This is with a full charged...
-
harryS replied to the thread I need help!!!.A box of junk controllers looks like this. You cannot tell much from the label. You have to look at the connectors. You need the wire...
-
-
harryS replied to the thread DIY build my own E-bike battery - tips?.Looks like a 4S-4P. Should hit 16.8V if the cells were good, Stuck at 13V. You might have all four groups at 3.5V, or more likely, some...
-
harryS replied to the thread I need a carry bag for a foldable ebike.My Schwinn Loop came with a carry bag, but those are narrow 20", and that's a 33 pound bike before I added a 6 lb motor, A 20" fat...
-
-
harryS replied to the thread DIY build my own E-bike battery - tips?.There is a test standard that says a cell must not start a fire if you short circuit it. Quality cells have pressure sensitive circuit...
-
harryS replied to the thread DIY build my own E-bike battery - tips?.FYI. He needs insulating washers over the positive terminals. It's for reliability over time, and also good insurance if your weld is...
-
harryS replied to the thread DIY build my own E-bike battery - tips?.Samsung 50S, a 5AH 21700 rated for 25A if you can keep it cool. Otherwise, should push 10A easy and if you had a 14x4 array, that's a...
-
harryS replied to the thread Crazy Walmart mid drive deal $349.I am lucky in that every time I check the link, it's out of stock. Would have bought one to go with our other six bikes, and I believe...
-
Update: I've had the bike a few days now. I've updated my original post to change the motor version from the V20 75nm to the current...
-
harryS replied to the thread First Build Direction; Test Motor Voltage, Safety Logic.Gromike has steel forks on his front drive bike, as I do on mine. Alloy forks are brittle and likely to snap at the slots where steel...
-
-
harryS replied to the thread Creo 2 Dork Disc Removal.I like the looks of a shiny steel dork disk. If it were yellowed plastic, it might go away,
-
harryS replied to the thread First Build Direction; Test Motor Voltage, Safety Logic.Most 48V controllers will run on 52V, but the low voltage safety will be set for 40V, about 3 V too low for the 52V battery, This is not...
