harryS's latest activity
-
harryS replied to the thread Bike Computer/Speedometer Recommendation for eBike.I have a handlebar USB accessory jack on one bike. After I installed it, my wireless computer couldn't get a signal from the wheels... -
harryS replied to the thread cheap hitch carrier - better ways to secure the wheels?.The last two racks I owned used metal loops to hold the wheels. Wheels would be well secured by gravity, but you wanted to use the velco...
-
harryS replied to the thread Electrobike seal 500.Well, if you still have the battery cannister, a re-cell service could transplant the cells and circuitry from another battery into it...
-
-
UPDATE: It was the spokes. I brought it to a bike shop and they tightened/balanced them all and froze them into place.
-
harryS replied to the thread Electrobike seal 500.Is this your bike? Unfortunately, it uses something like the common 36V Silverfish battery but not quite the same. Doesn't use a rear...
-
harryS replied to the thread Choosing the best conversion kit.Here's a cheap Cruiser I did in 2018. Bought a used bafang front motor and a used 36V nineboot scooter pack for $100. Motor...
-
-
Ok guys... Whenever doing a continuity test you not only test pin to expected pin but pin to all pins. AND FIRST you isolate the...
-
harryS replied to the thread Brose motor repair.Have you tried torquing down the pedal arms, replacing the pedals and finally tightening the motor mount screws? I've found all kinds...
-
harryS reacted to C-Jay's post in the thread [SOLVED] Bafang BBS02 : crackling noise when pedaling : any idea why ? with
Like.
I recently experienced the same problem. A sort of grinding noise as shown in the above video. As I started to remove the BBSO2 from... -
harryS replied to the thread Standing Up on ebike: safe?.I got the motor so I wouldn't have to stand up on hills. Ugh, the bad old days when I would crest the hill at 6 mph, standing while...
-
harryS replied to the thread Jetson Ryder Pro jry350-gbl water.Lithium batteries use a battery management system (BMS) for safety. The BMS monitors all the cell voltages. If any are too low, it opens...
-
harryS replied to the thread Temporary power outages and motor noise.This sounds like a Hall sensor problem. They're inside the motor. Falling over should not affect them as they are tiny. PCEbiker put up...
-
-
harryS replied to the thread Jetson Ryder Pro jry350-gbl water.Unplug the controller from the battery, if you can. Then measure the battery voltage at the plug with and without charger plugged in...
-
harryS replied to the thread Ecotric Dolphin brake upgrade/motor cutoff.I've added switches to the MT200. Basic kit is a round magnet with a hole in it, and a plastic switch box with a normally closed switch...
-
-
harryS replied to the thread Jetson Ryder Pro jry350-gbl water.Specs say 36V battery. That means a max voltage of 42.0 V at full charge. The scooter will run til the battery gets to around 30V. Then...
