Recent content by Falcan

Yes the hard part was finding a replacement that had all the same specifications (tapered/straight, QR/Thru-axle, disc brake offset). Otherwise you may have a little more work (depending on what facet doesn't match). The fork I got (which was an exact copy of the one the bike came with)...

Do forks use a standard screw size?

So I crashed my bike and had to replace the front fork. I got a new fork and installed it, but wasn't able to ride due to bad weather until today. When I put the disc brakes back on I noticed the bottom of the two screws that holds the brakes in place wouldn't tighten all the way. It goes...

Attached is my recent bottle cage addition. I got this (amazon) cage and attached it to my rear rack using one velcro cable tie on the bottom and one in the middle attached to the strap on that bag. The bottle cage position under the seat that the bike came with was very small and I actually...

Hi, I crashed my Yukon 750 yesterday (paved path + downhill + try to turn + little sand/rocks = sliding along ground) and bent/twisted/broke the Mozo Fatman that it came with. I ordered another Mozo Fatman since it seemed like the cheapest option and I know it will work with my...

Ok thanks for confirming it needs to be replaced. I just ordered another Mozo Fatman since it was cheap and I knew it would work with my bike without needing other changes.

It is definitely twisted and I'm planning to replace it. I'm more of curious just how damaged it is. So twisted means need a new one? No just twisting it back?

Hi, I had my first crash today going downhill on a paved path that had an S-bend in it. I hit a little bit of sand/rocks and slid along the ground a ways. I'm ok except for scratches and bumps (lesson learned for future), but there was some damage to the front of the bike (see pic below). Do...

I forgot to mention I have the 2018 Yukon 750. Here is a picture when I unscrewed the top screw (which was about an inch and a half or so): I didn't try pulling on the silver part there to see if it came up any more. Should it? What attaches it at the bottom? It's looking like I would...

Hi, This isn't really Voltbike specific, but I have the Promax Stem that comes with the Voltbike pointing straight up at the sky (as high as it will go). I think I need it to be just a little bit higher. The stem has the upper black portion and the bottom silver portion. Can I raise it up a...

I haven't noticed the noise being that much louder than the hum the motor makes, but I do notice the difference when I go onto the grass.

Good point. I believe they are stainless steel since they came off an old bike basket, but I wasn't thinking about that at the time.

I was having trouble finding a bike rack that would work for my Class I trailer hitch, while supporting an E-Bike weight (Yukon 750 is ~62 pounds without battery), support 4-inch tires, and not cost an arm and a leg. I don't know about lifting the bike up onto the hanging style racks (or how...

It is a PRO number and it will take a day to show up in the system after you get the tracking number email.

How exact are the weight limits for bike racks? If one says it supports up to 60 pound bikes how worried would I need to be if I put a 62 pound bike on it? If one holds four bikes up to 45 pounds each can it hold one 62 pound bike?