Recent content by darren_29

i agree, but both connectors are the round green 5 pin plugs, but only difference is that my new display carries a 5 pin female instead of a 5 pin male, that is why i had in mind to get another cable with the corresponding green 5 pin male plug and in number and colour order re-wire into my new...

sorry for not returning messages as I've not been well, but I've been thinking? what if i was to rewire my new display is the same was that my old display is wired in number sequence? for example::: if i was to try and get the wire with the male plug and with the same wire colours as my...

hi just want to know settings do i need to use on my voltmeter to do this test? the image below is my voltmeter that i have? i will await for a reply. thanks

hi i will do this check tomorrow and post the results as from the last post that the pinhole at 1oclock is the red + and no.2 is - but i will do this check with the voltmeter

can i test the power to my new display just by connecting the the positive to the positive connection and the negative to the negative connection to see it power goes to my p850c before i continue with the other connections ? i am however waiting on a cable with the 5 pin male to do this as i...

so i would have to scramble the wire colours of the p850c to go in unison with the colours in order of the controller display. Bypassing a straight thru cable? would that be anything to go? Obviously i would have to put the power and ground connection in order with the controller. but on the...

hi one more thing as you see from the continuity test i did on both my c965 display and my p850c display. you mentioned about scrambling the wires around. is that so it goes in sync with the colours from the c965 display order even tho the colour of some of the cables on the p850c display...

and for your last post.. i did follow what you placed

just another thing as i would imagine that this would be my controller so to speak well similar but connections would be the same except mine as one extra for battery which i will put an image of what i have on my e-bike, but this should once all is correctly wired in prospective as to how the...

hi, when i got the extension cable with the two male plug's on each end and connected to my bike and powered up my bike then tried to power up the p850c not thing happened, and for the order i looked through a magnifying glass and the connector which i saw how it was numbered being 1 the 2 as...

hi this is my conformation that what test i did this morning on my current display is correct with this diagram. i will post both male connection and female connection, however as you have seen from my p850c display the colours of the corresponding wires differ than my c965 display.

hi . ive done the continuity test on my display (c965) and also taken photos on my display with connections both from display and leading from my controller to the display. As you will see the the connection from my display is male, where the connection from my controller that my display...

hi what i can do in a bit is remove my display i have now and make a photo of it with the connection plug, also will do a continuity test on that display too, but as for the continuity test on my controller i think that would be a bit difficult but i can certainly make a photo of my display and...

here is the display wiring diagram but mine has a white wire instead of black but i think this will give an idea as to where each wire goes and what its job in hand is. image attached. bearing in mind that colour of wires shown here differ to mine in my p850c display..

ok continuity test done on each pin to the corresponding colour of wire inside the p850c display.. the findings are as follows...... pin 1 = orange pin 2 = white pin 3 = brown pin 4 = blue pin 5 = black i hope that with this information will be useful in hoping that i can wire correctly and be...