Latest activity
-
I thought the measurement was called 'stack'. Make a horizontal line from the top of the steer tube back to the seatpost and from that... -
-
I'm going to be in a world of hurt if I slip off the seat of my electric monstrosity,.. If I land hard enough, I could even set the...
-
. . . or testicles 🙃
-
RunForTheHills replied to the thread Clean Custom Conversions.You do a great job of hiding wires and I like the look. Like many here, I have the bike collecting sickness and enjoy looking at all... -
I remember reading how the 700C measurements started going wacky when the racing teams started making their wheels a tiny bit smaller to... -
PedalUma replied to the thread Clean Custom Conversions.That is how I understand it. For my 60cm classic Euro frame the seatpost is raised by 20cm and it has a long quill stem puting the grips...
-
Stack would certainly be more useful for modern frames. I had to get a short, high rise, stem for my Raleigh when I rebuilt it because...
-
Kkevinmccune replied to the thread 4 better then 3?.good point,a lot of paths are not golf cart friendly or any atv's.
-
KThat might be more of an issue elsewhere (than the US), but it’s a really good point. It’s possible you’d be excluded from some...
-
KAt 4 wheels you are no longer considered an electric bicycle as trikes are.
-
KI think that a tilting design would be less likely to tip over with either three or four wheels.
-
RunForTheHills replied to the thread Clean Custom Conversions.Stack would certainly be more useful for modern frames. I had to get a short, high rise, stem for my Raleigh when I rebuilt it because...
-
Grin (ebikes.ca) recommends Mobilegrease 28 for hub motors they sell that have synthetic gears (I was asking about my Shengyi hub...
-
PedalUma replied to the thread Clean Custom Conversions.I thought the measurement was called 'stack'. Make a horizontal line from the top of the steer tube back to the seatpost and from that...
