Thank you. I was afraid it would be a mystery connector. I cant see spending $600 for a replacement battery just because of a connector issue. I guess I'll use a 30 amp Jones 2 pin plugs and sockets and 3d print housing adapters so they fit the battery and holder.
I really liked the split power cord. That is a MacGyver if I every saw one. Clever. :=)
Actually, I can't take credit for that one. I saw the idea in another thread here at EBR. I don't remember the poster or I would have given him credit.
Thank you. I was afraid it would be a mystery connector. I cant see spending $600 for a replacement battery just because of a connector issue. I guess I'll use a 30 amp Jones 2 pin plugs and sockets and 3d print housing adapters so they fit the battery and holder.
I really liked the split power cord. That is a MacGyver if I every saw one. Clever. :=)
Why not get that proprietary connector out of the equation? Set the battery up with a short pigtail and your favorite connector, then do the same on the other side. Use quality wire (12ga) and connectors and you should never have any trouble with it.