oren8714
New Member
Hello all,
I am new here so sorry if I writing something that was written before .
I have 1 year Magnum peak 48V 27.5 , week ago it started to have problems , motor stop work during cycle etc..
but currently I have a problem that motor goes well with hand throttle but not going with pedals , more than that , I cant see the speed read on the LCD , always zero , with throttle and will normal pedal , always zero .
I tried :
1. several changes in the LCD configuration (DAS-KIT C7) , size of wheel , power, everything - no change.
2. tried to check and reconnect all connectors from controller/LCD , include break sensors , everything , all ok- doesn't help
3. I even replaced the PAS on the peddle to another original one - doesn't help
much appreciate some help and suggestion
thanks
Oren
I am new here so sorry if I writing something that was written before .
I have 1 year Magnum peak 48V 27.5 , week ago it started to have problems , motor stop work during cycle etc..
but currently I have a problem that motor goes well with hand throttle but not going with pedals , more than that , I cant see the speed read on the LCD , always zero , with throttle and will normal pedal , always zero .
I tried :
1. several changes in the LCD configuration (DAS-KIT C7) , size of wheel , power, everything - no change.
2. tried to check and reconnect all connectors from controller/LCD , include break sensors , everything , all ok- doesn't help
3. I even replaced the PAS on the peddle to another original one - doesn't help
much appreciate some help and suggestion
thanks
Oren
