Search results

Hi Did you ever find out the sizes either from information provided or after you removed the bearings. After 30000+km iI think mine are due for replacement.

Remeber the hoary old one about assume making an ASS out of U and ME

2 pin. But isn't the answer obvious from a casual observation?

4 months since your original interest, where have you been I replied to your pm sent today before again reading this thread!!!!:-)

If your bike can already reach 45km/h, this will not make it go any faster.

if anyone knows of a UK supplier for male/female plug complete at a reasonable price? Lots of suppliers on Aliexpress. Search for Reention Dorado 2 pin

Did you eveer open new posts regarding the "ignition" switch and the GPS incorporation?

1. Are you still searching and are you in Europe. 2. If so pm me.

On my bike I cut into the wires joining the display and the controller at top of the Downtube above the battery. The device I built for someone else was pretty much identical to the German eBay device ie daisy chained using Julet connectors. The solution on my bike was cheaper and tidier but...

I have installed a dongle on my NCM Moscow which raises the speed achieved by the motor before it cuts out, and removes the flat spot as the speed drops below 25kph. The device is probably the same as the German eBay referred to in the previous posts, but cost an order of magnitude less. I have...

I have, perhaps foolishly, fitted inexpensive XOD XD-D800 hydraulic brakes to my e bike. The brakes were supplied without documentation and the eBay supplier has not produced any despite my determined efforts. My dissatisfaction with the supplier has been reflected in the rating I gave them...