Search results

How to adjust Gates belt tension on R&M Delite. Tools Needed: 1) T30 Torx Bit and torque wrench 2) 3mm Allen hex key 3) Gates Kriket Belt tension gauge 4) flashlight The recommended belt tension is between 28 lbs and 40 lbs. My gauge had graduations at 30 lbs, 40 lbs, 50 lbs and so on. I...

Folks, thanks for the advice. I'll adjust the belt tension based on your suggestions and report back.

Thanks for your reply. The screw is kind of perpendicular to the spring's axis. But I think tightening / loosening the screw will perhaps fine tune the tension. However, I didn't examine the rear hub closely enough. Turns out there is a mechanism to adjust the tension back there. See below...

Yes, there is a pulley connected to a spring via a lever that maintains tension. Also, near the hinge point of the lever there is a slot but it doesn't quite look like that hinge point travels in that slot. In the videos on YouTube that I alluded to, they were adjusting the tension by turning...

Using a Kriket measuring tool, I checked the Gates belt tension on my Delite and it is lower than spec -- it currently stands at 22 lbs or so. It's supposed to be between 28 and 40 lbs. How do I go about tensioning the belt? Can someone point me to a video or other resources showing how it's...

That was my expectation as well. I waited for the 400 mile / 3 months free tune-up and drove up 60 miles with the eBike to have them fix it. The service tech said it was a faulty high/low switch and he'd notify me when a replacement arrived. I wasn't convinced, so I checked the switch. It works...

Sorry, you're right -- my Delite (2021, GT, Rohloff HS, Nyon, 625 Wh, Air-suspension upgrade, GX) is equipped with the Supernova M99 Mini Pro-45. It came like that from the factory (i.e. not an aftermarket upgrade). The Nyon buttons turns it on and off. The rear lights / brake lights work as...

I can't get the High Beam / Low Beam button to work on my R&M Delite equipped with the Supernova M99 Pro 45. Clicking the button does not do anything. However, I can turn the lights on and off using the headlight switch on the Bosch Nyon. I took it to the dealer to have it looked at and the...

I believe you, but Bosch's documentation is all over the place. The 2020 Nyon manual on page 11 says "Max. USB charging current (output)" is 1500 mA. If it was input, it would just say how many milliAmps the unit consumes while charging. The fact that it specifies "Max." and "output" would...

Sorry for jumping in late, but I saw this on the Bosch website. "Smartphones can be charged via the USB port of your on-board computer." It doesn't name any specific computers, so I assumed all of them (including Nyon) do...