Search results

Yes same issue with the S830 display that comes with the waterproof kit. I haven't hooked up PAS yet, because I need a magnet disc compatible with a hollowtech spindle, and also hydraulic brake cutouts. Both are on their way.

Respectfully, I'm not going to throw the battery under the bus until I get some better solder joints. Also, yes, this is uphill with about 90# including the weight of the Burley hanging off my rear axle, so the mph definitely isn't the whole story.

It's a 36v 12ah "Samsung, Lg,and Sanyo 18650 cells", and only 500wl watt motor. Purchased from eBay vendor with good reputation, and sitting in a waterproof trunk bag. I bought a watt meter, but haven't soldered the connections for it yet. Also... I did have to solder a longer wire on, and my...

Have taken my first couple rides on ebikeling kit, and noticed that the battery capacity will drop to ~25%, with about moderate throttle (only going 10mph). Then when I get home I can watch it rebuild to about 85% after a few seconds. What does this mean? The only way the controller knows the...

New controller worked! Old one was only putting out 4.3v on the throttle connector, new one is 4.75.

Same physical connector, but one is obviously for the throttle, as it's at the end of the breakout cable with the display and the brake connectors, while the other is separate, and short, and requires the long cable on the PAS sensor.

Well, that works. Still, nothing else does. So what does that mean? Bad controller? Ebikeling said to make p07 and p08 at 100, and both now are, but no change. Emailed them with updated results. Awesome to see it move...finally.

Don't think I have a V button. What is that?

New conversion kit, and I'm getting no response whatsoever from either the throttle or the PAS. Battery is putting out 40.5 volts, and it's a 36v motor. Controller is set to 36v, and it is showing battery is 100%. I went through the settings, and made sure P10 is set to 2, which enables both...

I was on the verge of buying a TSDZ2 for this exact reason, as it uses torque based assist. Ended up just going with a front motor ebikeling, and plan to use the throttle to assist on hills, while hauling kids. Also, assume you've read this...

Why don't hoverboard batteries have separate charge leads from the discharge leads, like ebike bateries do?