Search results

Yes I know its not normal but its consistent, I have the multimeter connected to ground and signal, every time a magnet passes the sensor the voltage spikes to 0,016V then drops to 0V again. As mentioned earlier I'm not even sure that the replacement sensor was working from the get go.

Its one of those simple ones with 3 buttons boost pas, lower pas and wall funktion. All the buttons and led indicaters seems to work though. is there a way for me to test the panel before I go out and replace it?

thanks for the reply guys. Can't say much about the brand other than I think its just a generic Chinese one. I have already tried rotating sensor and rotating the disk while spinning the bottom bracket forward and backwards with out any luck. ops Harry your right that was a typing error, the...

Hello fellow bike fanatics. lets cut to the chase. I have problem with my mother in law's older ebike (2010 ish), she brought it to me because her pas system stoped working suddenly. So I checked the bike over, witch gave me this to work with. 24v Battery - holds a charge, and when connected...