Search results

As I get older my free time becomes more valuable. With my current responsibility load if I have a few free hours I'm going for a ride before fixing something that ain't broke.

What makes Mucoff the best? Is it soy based? 🤣 Now using Flatout I can tell it's better than Slime for not drying out and being thicker. It does make it a little harder to get in but nothing ridiculous. I'm not experiencing flats and I'm curious to pull the tire and check if there were any that...

What I've been doing is putting a drop of water in the valve stem and blasting air in before checking and setting air pressure. Even with grease if you let air out first some sealant comes out. So far never a failed valve since implementing this practice the past few years. I've been meaning to...

I don't believe they do directly... But resellers can be found on Amazon, eBay and Aliexpress etc....

APT makes a lot of Bafang compatible displays. I love the my APT 860C.. But it is big. Just make sure you match your communication protocol. UART or CANbus

I've used both and I prefer Flatout over Slime. That said 7000 miles with Schwalbe flat guard and 1 flat when I picked up a big rusty nail on the grass shoulder of the MUPS. Imo it would have gone through any protection. We seem to ride similarly.. though I head off road occasionally. I bought...

If you want to try and keep the ones you have you can try cleaning them (the inside) and the bar ends well.. Like with some isopropyl alcohol.

.. and we're back to jizm 🙃

Though most soap is considered safe to use.. Most commercially available tire mount lubes are vegetable oil base. On my bike I've used some diluted Simple Green with good results.

Yes, petroleum based oils especially. Rubber will swell and split. Most lube used in conjunction with rubber is silicone based.

Try jizm' Adherent, all natural, biodegradable and impervious to rubbers 🙃

Well technically that's true... but you'd be surprised at the amount of talent out there that's capable. I guess your Mrs.'s was able to walk it off after all... 👍

Things should work as before the charger was damaged.

You probably have poor connections then. The wire is stranded and most likely some of the strands broke leaving you with very little copper to carry the current. You'll need to make a proper repair or replace.

Was the charger plugged in when the dog attacked it? He may have damaged it. Test the voltage output. Otherwise you may have a poor connection at your repair. Crimp like those suggested work well for this type of repair.

You try carrying around a third leg... After a while being called tripod isn't funny anymore, especially when the ladies scream bloody murder. 🙃

Probably ash from the chopstick

LVC is the voltage the bike shuts down to protect the battery. There are two.. One in the battery, the other in the motor controller. Typically set around 40 - 41v on a 48v battery Ah is the amount of stored power. Generally higher Ah batteries will have greater range and lower voltage drop on...

OK... measured and as I ASSumed. Monarch is 15mm eyelet without bushing. DNM is 14mm You can measure accurately enough just viewing the profile. I doubt you will find the needed bushing as it would be kinda thin with a 0.65mm wall thickness. I guess one hack would be to sand it from 12mm to...

Well hold on... Not sure you'll find the size needed. Both Rockshox and DNM have bushings in the eyelet from the factory to protect the eyelet. This way when it wears you just change the bushing. Initial search tells me.. Rockshox is 15mm OD to 12.7mm ID DNM is the 14mm OD to 12mm ID. The...