Search results

  1. britannic

    Replaced My Stromer ST2 S with an ST7

    Yes, I can bring the bike to stop with two fingers on the front brake.
  2. britannic

    ST7 setup, what to check?

    Check all of the fastener torques, make sure the kick stand spring doesn't rub on the rear tyre when folded up. ABS works fine, unless a fault is signaled or there's air in the line.
  3. britannic

    New Stromer flagship ST7

    Mine closes, but won’t positively latch, it does require effort to open (won’t easily pull open with the ring pull catch) by hooking my fingers into the gap at the top of the cover. I wouldn’t trust it to stay closed in transit though.
  4. britannic

    Replaced My Stromer ST2 S with an ST7

    Now the front brake is bled, the ABS is brilliant for emergency stops!
  5. britannic

    Stromer announces solid state ceramic battery prototype

    This article has some details on the development of the ceramic battery: Researchers at the University of Michigan may have solved these problems with a new type of battery.
  6. britannic

    Replaced My Stromer ST2 S with an ST7

    Yes. The rear was excellent once bedded in and so is the front, now the air has been bled,
  7. britannic

    Replaced My Stromer ST2 S with an ST7

    I was able to solve my issue by setting the bike and FB vertically in my bike stand for 2 days. This allowed the trapped air in the convoluted ABS hydraulic lines to travel up to the FB reservoir. Periodically pumping the FB lever during this time did the trick. The LBS had already tried to...
  8. britannic

    ST7 Gates Carbon Drive CDX Belt Part # Needed

    This part number is confirmed for getting the Gates belts outside of the Stromer dealer network.
  9. britannic

    Replaced My Stromer ST2 S with an ST7

    I read that one as well. The LBS has the same thing I do, which is a specialized syringe.
  10. britannic

    Replaced My Stromer ST2 S with an ST7

    Alignment is correct and the pads are showing full contact. I’m convinced the front brake needs bleeding, there’s a smidgen of sponginess compared to the left. My LBS had difficulties with the front and explained the challenge is with the convoluted routing of the lines through the ABS. If...
  11. britannic

    Replaced My Stromer ST2 S with an ST7

    So I switched the rear brake pads with the front pads. For the first 4 full stops, the rear brake screeched some, then was silent thereafter. The rear has the same full brake force as before the pad swap. The front brake was silent, but still not strong. In fact on a moderate downhill descent at...
  12. britannic

    Replaced My Stromer ST2 S with an ST7

    Perhaps the additional steps are to do with removing the shifter casing, due to differences between the manual and electronic shift systems.
  13. britannic

    Replaced My Stromer ST2 S with an ST7

    In that case, so do I!
  14. britannic

    Replaced My Stromer ST2 S with an ST7

    I’ve bedded the brakes in using TRP’s instructions (30-40 full stops). However, the front brake isn’t able to normally stop the bike from 20mph (note, normal = not actuating ABS). This is in comparison to my ST2s. Blu Brake states the front braking should be normal force, unless ABS is...
  15. britannic

    Replaced My Stromer ST2 S with an ST7

    Yes I do. Very straightforward, Pinion has a how to video.
  16. britannic

    Replaced My Stromer ST2 S with an ST7

    For my braking concerns, Tektro (TRP) are recommending 30-40 hard full stops to bed them in. I’ll report back on the results when I get an opportunity.
  17. britannic

    New Stromer flagship ST7

    And definitely don’t drop the battery onto something hard, most likely will destroy it or make it unsafe.
  18. britannic

    ST7 Gates Carbon Drive CDX Belt Part # Needed

    Thank you @AbeK!
  19. britannic

    Replaced My Stromer ST2 S with an ST7

    The pinion is very smooth, but won't change gears under heavy load, so I need to shift early before climbing hills, unlike a derailleur. IMHO the ST7 belt is quieter.
  20. britannic

    ST7 Gates Carbon Drive CDX Belt Part # Needed

    Only the top half of my ST7 Gates Carbon Drive CDX belt part number is available and what there is already worn after a couple hundred miles. I counted the teeth and came up with 113. Does anyone know if this is correct part number? 11M-113T-12CTS BLACK (other colors are: BLUE or BLACK W/R)...
Back