wildtrak's latest activity
-
wildtrak replied to the thread Bosch Walk Assist (Not Smart System).That's what it is supposed to be. It is meant for pushing it up some steep ramp or very steep sections when MTB. Especially when loaded... -
wildtrak replied to the thread Bosch Walk Assist (Not Smart System).They do. Try again. The motor spins a certain fixed cadence. It even works with no speed sensor. Even the cut-off speed is ignored. You...
-
wildtrak replied to the thread Bosch Walk Assist (Not Smart System).Walk assist goes 6kph in the fastest gear, so you should have used a faster gear. That is set with the maximum gear ratio. And never...
-
wildtrak replied to the thread New Bosch Gen1–Gen4 Unlock Tool – No Chip, No Errors, Full Reset.There is no risk in changing the wheel circumference. I do that all the time. And yes, the odometer and speed will be off by whatever...
-
wildtrak replied to the thread New Bosch Gen1–Gen4 Unlock Tool – No Chip, No Errors, Full Reset.Same here, but for the Bosch I do it myself. I even cranked up the torque by modifying the electronics. The one rebuilt Gen 2 Active...
-
wildtrak replied to the thread New Bosch Gen1–Gen4 Unlock Tool – No Chip, No Errors, Full Reset.Just go to your local metal shop and they can make a disk like that for $20. It is scary how easy they make it to get around the...
-
wildtrak replied to the thread New Bosch Gen1–Gen4 Unlock Tool – No Chip, No Errors, Full Reset.I actually do that for free for my friends here or if I sell a motor. Setting the wheel circumference to half shows half speed. Cuts off...
-
wildtrak replied to the thread New Bosch Gen1–Gen4 Unlock Tool – No Chip, No Errors, Full Reset.Even Gen 1 (not released in the USA) has USB via Intuvia (but not the old HMI) All BES 2 bike computers have USB. I guess this user just...
-
wildtrak replied to the thread New Bosch Gen1–Gen4 Unlock Tool – No Chip, No Errors, Full Reset.There is no such thing as a Gen 3 Performance Line CX.
-
wildtrak replied to the thread Random power issues with error code that the battery disconnects..I have seen Bosch batteries where the plug/flat connector was not fully snapped in on the BMS board. You wiggle it, it disconnects and...
-
wildtrak replied to the thread Dreaded Error code 500 after 18000+km. Can I just swap a motor?.That's a bummer 😐
-
wildtrak replied to the thread Dreaded Error code 500 after 18000+km. Can I just swap a motor?.No. But it does fix it most of the time.
-
wildtrak replied to the thread Dreaded Error code 500 after 18000+km. Can I just swap a motor?.Any BES2 motor works with any BES2 display. If it is an Active Line, you can even make it more powerful than a CX by adding 2 510 Ohm...
-
-
wildtrak replied to the thread Dreaded Error code 500 after 18000+km. Can I just swap a motor?.It will work. Unless you have eShift and get one for Derailleur. You cannot reprogram it. Only a few people or the manufacturers can do...
