Tom521's latest activity
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.On further consideration it would be lovely to be able to reprogram the present Lectric ONE controller to be more linear with the...
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.At long last I removed the CA-V3 and associated wiring and put it in a box, leaving the ONE in its original electrical condition. A test...
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.LOL! Maybe I could use two of them in series to do the 6-speed Smartshift?
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.PCeBiker, Here's a quick look at why it seems problematic. The cables coming out of the present controller are identified by Lectric...
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.6zfshdb, If this was a straightforward ebike I might agree that replacing the controller is an answer, and maybe in the long run that's...
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.I tried to research the controller that Lectric uses in the ONE. Haven't found any information yet. My hope is to find some information...
-
TTom521 reacted to PCeBiker's post in the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE with
Like.
What about trying to set up your CAV3 so that a throttle input voltage of 0.8V to 4.2V puts out a 0.8V to 1.35V to send to your... -
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.Does anyone know whether the Lectric controller can be programmed using the STM32 ST-LINK software?
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.Well... Checked voltages and learned some things I didn't wish to learn. Ain't that always the way? First, output from the throttle is...
-
TTom521 replied to the thread Can Lectric's ONE be converted to kt-lcd3?.Not looking good for the home team: if the controller gets more than 1.35V it goes wide open. Interestingly PAS1 is a slower wide open...
-
TTom521 replied to the thread Can Lectric's ONE be converted to kt-lcd3?.RunForTheHills, A wee bit of progress. Lowering the Throttle Up Rate did seem to take some of the lurch out of the startup. Progress...
-
TTom521 replied to the thread Can Lectric's ONE be converted to kt-lcd3?.RunForTheHills, Thank you. Headed to the garage to try some of this. Any smoke you may see is probably related to some Anglo Saxon...
-
TTom521 replied to the thread Working to put GRIN CA3-DPS + External Shunt onto Lectric ONE.It becomes more obvious I need to learn the CAV3 throttle niceties. In re-reading the manual (OK, I'm a slow learner), the throttle...
-
TTom521 replied to the thread Can Lectric's ONE be converted to kt-lcd3?.PCeBiker, Had to cancel the controller order. In reviewing this video: https://youtu.be/87TaN6IDn8M?si=w6Jm6N9MD4VZDn1B it became...
-
TTom521 replied to the thread Can Lectric's ONE be converted to kt-lcd3?.Ordered one. Continuing this thread at...