Recent content by stevenmp3

Hi can anyone tell me where I can purchase one of these controllers in the UK if possible,thx

Hi,I have two ebikes,both of them have the same set up , 72v with 3000w hub motors ,both use a ukc1 display with a 60a controller, my first bike the throttle will only go to the speed of what pedal assist you have it in,so pulling away using the throttle in a low power assit level is...

Hi,I have two ebikes,both of them have the same set up , 72v with 3000w hub motors ,both use a ukc1 display with a 60a controller, my first bike the throttle will only go to the speed of what pedal assist you have it in,so pulling away using the throttle in a low power assit level is...

Bingo

I have finally fixed it,I just replaced the IRFR9220 chip is,cost £4.95, it fired up straight away so no need to replace the ss210 ,thx for all the advice ,i hope if anyone out there trying to wire a light using the 12v supplied by the controller comes across this problem it will help...

I tried to use a step down on the 12v out on the controller,i used a 12v to 9v to try and power my led light , am only going so far with the repair,but i have a soldering iron and the will to use it,

The IRFR9220 chip is being delivered first,is it ok to fit it to see if it works or shall i what until all the parts turn up,l would like to add i am never ever again going to use the light connector thx

Thanks for your help,i think i have found the parts to hopfully fix it,SS210 SMA JD Schottky Barrier Diodes and a VISHAY SILICONIX IRFR9220TRPBF MOSFET, P CH, -200V, -3.6A, TO-252AA

Good afternoon,can you plaese help me ,i have blown a chip and was wondering if someone could tell me what chip i need to replace it,it happened when i wired a light and its blown a chip in the ukc1 display i have thx steven

Can any one give me some advise on error code 10,it all started after my 1500w rear hub motor started spinning backwards,i plugged my ebike tester kit into the hub motor and controller and discovered one of the hall sensor was blown in the hub motor,i replaced all the hall sensor as i...

Hi ,i am having to replace my hall sensors and after examining my hub some of the plates are loose and one of them has prized away .can i superglue the loose ones and push the plates back or is this nothing to worry about,thx

Hi ,have you sorted out your problems with your pedal assist yet,i am having the same problems , its way way to fast ,my ebike kit has the same controller as yours and the manual's i have downloaded are all different and I don't know what the pwm and auto assist do ,thx

Hi i have a ukc1 display,does anyone know what setting i should use in ,advanced settings , throttle pwm ,at the moment its set to 00,thx

i have just brought a second hand front wheel and it looks great in gold ,its a Sun Ringle Drift 2.1,i have a chance to purchase the rear wheel and was wondering if i can replace the Sun Ringle MTX39 rim on my 3000w ebike hub motor for a Sun Ringle Drift 2.1 ,thanks

I have tried another 72v controller and it doesn't seem to work properly, the throttle only goes to the speed of what you have the pas set to, its making 3200w and is slower and far less torque,the 52v battery was making 1850w and has far more torque and i can get the throttle to go flat out...