spokewrench's latest activity
-
Sspokewrench reacted to Gionnirocket's post in the thread splicing Julet 4 pin tail light cable with
Like.
My tip with most products like this is to not cut the applicator tip as instructed if it has a screw top and use a pin or small artist... -
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.I tried that with my Radmission after I discovered that the tail light did not have a reflector lens. I figured in that case I should...
-
SOr, another option, spoke, is to cap/disconnect the wire and use a battery-powered (self) tail light instead. That’s (unfortunately)...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.I'm sure they shorted when I mashed them under the center stand mounting. With the extension, I can see if the circuit still gets power...
-
Sspokewrench reacted to Slaphappygamer's post in the thread splicing Julet 4 pin tail light cable with Like.
Looks like you can remove the taillight from the rear rack. If you can, then remove it and move it closer to the controller and pull the...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.In August, 2024 I ordered two 50ml bottles of "5210 Solder Multi-material repair adhesive Oil based glue." It turned out to be super...
-
Sspokewrench reacted to Gionnirocket's post in the thread splicing Julet 4 pin tail light cable with Like.
I would silicone on things like canvas which worked well... but that's also what I had on hand. I try not to buy to many specific...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.Failed. I came to see that the slack is necessary to slide the controller out of its cubbyhole. It cost me half an inch to splice the...
-
SGot it, spoke... Glad you have the slack you need to do the splicing. Tallyho.
-
Sspokewrench reacted to Gionnirocket's post in the thread splicing Julet 4 pin tail light cable with Like.
The larger the shrink ratio the more versatile it is.. Especially when working with, or need to feed it over something like a connector...
-
Sspokewrench replied to the thread My "New" Ebike.That's a dad-gummed porcupine. He looks harmless after a veterinarian removed his quills, but salt is porcupine catnip, and a porcupine...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.Thank you! If I'd known then what I know now... This stuff should be great with uninsulated crimp terminals, which make it easier to be...
-
Sspokewrench reacted to Gionnirocket's post in the thread splicing Julet 4 pin tail light cable with Like.
I've done that as well.... Sometimes even putting heat shrink over it Typically the heat shrink with adhesive has a thicker wall and...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.Those are where the corners of the base of the center stand mashed it. As you can see, I was able to pull a lot of slack out of the...
-
-
S@spokewrench forgive me but I’m having trouble envisioning where that cable is on the bike. It’s so close-up that I don’t know what I’m...
