Shifty Shane's latest activity
-
Shifty Shane replied to the thread Lubing an eBike chain.I can lean my bike over on the kickstand until the rear wheel is off the ground, then rotate the pedals. I've also used a ratchet strap... -
-
I push my bikes over on the kick stand just enough to raise the rear wheel and prop it up some way. Get creative with a way to hold it...
-
Shifty Shane replied to the thread How accurate are distances on e bikes.In your controller programming settings, on the "Basic page" where you set the wheel diameter, try changing "SpdMeter Signal" (# of...
-
-
Shifty Shane reacted to Stefan Mikes's post in the thread How accurate are distances on e bikes with
Like.
This matter has been discussed in EBR Forums for many times. The short answer is: The accuracy of the odometer depends on the Wheel... -
Shifty Shane replied to the thread How accurate are distances on e bikes.With my wheel diameter set to 29" (actual is 28.8"), my speedometer and odometer are approximately 97% accurate compared to a GPS speed...
-
-
Shifty Shane replied to the thread Full face helmet for ebike 20-30 mph speed.I'm a bit late to the conversation, I got a cheap helmet for free when I purchased my used dual sport motorbike. I liked the looks of it...
-
-
Shifty Shane replied to the thread Bafang DPC-18 Ebike Display Settings.I'm extremely late to the conversation, but the DPC-18 with Eco/Sport modes 0-5 correspond to the Bafang programming software assist...
-
Shifty Shane replied to the thread Does changing the Display settings.Sorry I'm late to this conversation, you're controller programming settings or firmware must be what's preventing you from changing the...
-
-
Shifty Shane reacted to JGcycle's post in the thread Hello everyone, I'm new to e-bikes and I appreciate all the shared knowledge available here. with Like.
Welcome to the forum. :)
-
Shifty Shane replied to the thread Ultra Tuning: Decoding the Torque Tab's SPD Table.I understand what you're saying, I just thought I might as well eliminate any unnecessary variables, whether or not they will have any...
-
Shifty Shane replied to the thread Ultra Tuning: Decoding the Pedal Assist Tab.I agree that most of the PAS settings would be overridden by the similar torque tab settings, and any cadence assist should be...
-
Shifty Shane replied to the thread Ultra Tuning: Decoding the Pedal Assist Tab.From what I've read previously, I thought the "slow start mode" was the ramp rate from zero current to the "start current" value. This...
-
Shifty Shane replied to the thread Ultra Tuning: Decoding the Torque Tab's SPD Table.The RPM's aren't a necessary value, I was just wracking my brain after I measured the true wheel circumference of my 3" x 27.5" tires...
-
-
Shifty Shane replied to the thread Recommendations anyone? Offroad Mountain e bike.Take a look at Biktrix .ca, keep an eye out for sales. I got the Juggernaut Ultra FS Pro 3 for $3300 Canadian during their Easter sale...
-
-
Shifty Shane replied to the thread Need help on choosing my first e-bike! Want to purchase from website..Check out Biktrix .ca, currently having a BOGO sale on select e-bikes.
