Recent content by Ridetoglide

No, like Ahicks said the motors are identical in power. But because my custom uart program was so much smoother it felt like it had less power but that is only because the power delivery is more gradual. If i laid into the pedal with some force which i dont normally do the power was all there...

Lol... was that an intentional pun?

I just swapped out my canbus motor for a uart, although I am holding onto the canbus motor, if you get access to all the firmware files and it can be programmed like the uart version i will try it

I think i am going to use the canbus harness, just have to make sure the wiring is the same. I will have to change the 8 prong JST connector, female to male and cut off the triangle display fitting and splice on the circular fitting. I just have to test to make sure all the wires are the same...

My Settings:

An Update..... So the motor swap was successful. The Uart and Canbus motors seem to be identical in outer dimensions and shape so the Uart motor swapped right in. The process was a bit of a nightmare for several reasons. 1. Biktrix - it took biktrix a week to ship the motor and then another...

This is turning out to be a nightmare. I ended up ordering the Uart motor from biktrix, figured they would be able to provide support if i had an issue. It took them a week to ship it out after the order was placed and then another week for it to arrive. I just received the motor today and it is...

Agreed... there is a good chance i may not want to change anything. I would like to see what happens if I lowered base voltage by a few hundred while keeping the Frey delta voltage settings as published.

Thanks... That is what i suspected.

Does anyone know how the DPC-18 Display's Eco/Sport settings correspond with the 10 Limit Current (%) settings ( Assist 0 - 9 ) on the Basics page? I've read that assist 5 on the display for both modes correspond to assist 9 on the basics page but am trying to figure out which assist levels i...

I just ordered the Uart motor, display, EB Bus cable and speed sensor. I ended up ordering them from Biktrix which is good because of the support if any issues develop... I was originally going to order from Green Bike Kit. There is always some sort of snag with a project like this but...

I will have the cabus motor already... Worse comes to worse if the uart controller i purchased does not fit i will have a spare controller on hand incase i ever need it.

Actually ive been thinking.... I wonder how much is actually different between the uart and canbus motor besides the controller and torque sensor? If I were to take a canbus motor, swap in a Uart torque sensor ( assuming it would fit ), would the former canbus motor now be compatible with a...

If it came down to that and there were no other options i would look into modding a canbus motor to work with uart controller to work. At this point in time I am going to buy and replace the entire motor, display, wire harness and speed sensor. I will sell the used canbus motor on ebay to help...

Its not Biktrix fault, the frame manufacturer switched over to Canbus, it affected the Bikonit brand as well.