PedalUma's latest activity
-
I have one as well, but it's just the slotted holder without the tip scrubber. Works well when you're working on a table for a straight... -
I have one of those alligator clip third hands. Not as fancy as that one though. The one I have was kind of fidly to use. I saw this on...
-
I'm not a fan of butt splices for inline cable modifications. I'll admit, they are less prone to failure, but I prefer inline straight...
-
PedalUma replied to the thread Someone Left the Bike Out In the Rain.My spring loaded micro-SD card jumped like a flea and vanished, so I couldn't take a photo. If it was not rusted I would have made a...
-
PedalUma replied to the thread Wire Organizing- What Do You Use?.Tight. Maybe a little too little too little! A yoga babe knows how to shake it. Did you see an Irina Kovych video yet?
-
It's a necessity riding the streets and the MUPS with the oblivious. You're always stuffing things in little slits 🙃
-
PedalUma replied to the thread Wire Organizing- What Do You Use?.That is what I did on this BBS02. All the connectors are hidden in the phone bag. I just made a little slit and stuffed them in. Gone.
-
-
I use a little of everything... and do what I find appropriate or easier for the occasion. Just tried some of the solder heat gun butt...
-
I started using wire nuts as an electronics technician on a Coast Guard ship. I found them so reliable that I used them to connect the...
-
PedalUma replied to the thread Someone Left the Bike Out In the Rain.I laugh with you. For me it would also be in freezing weather and I would bust open an oil covered knuckle and then I would bag my head...
-
I learned by overtightening a steel oil drain plug into an aluminum oil pan
-
PedalUma reacted to Gionnirocket's post in the thread The Ultimate Mid-Drive Chain Care Thread with
Like.
You might be ok with the same chain legnth.. Imo there's a bit of a workable window on chain legnth. I went from 40t to 46t without... -
PedalUma replied to the thread Wire Organizing- What Do You Use?.
-
-
I do the same for fine wire work. Soldering and covering with heat shrink makes a clean sleek joint that doesn't "bulge" like crimp...
-
PedalUma replied to the thread Someone Left the Bike Out In the Rain.It was one of those cranks on a Raleigh Mixte that I learned the lesson of over tightening at 14. Up until then everything got tightened...
