Old-tool-guy's latest activity
-
OOld-tool-guy replied to the thread When Paris started dropping cars.Just couldn’t let it go, could you?
-
OOld-tool-guy replied to the thread When Paris started dropping cars.Do you have proof? He has been accused a couple of times, and there have been trials, but he was not convicted. And all of the...
-
OOld-tool-guy replied to the thread When Paris started dropping cars.I can understand it in SF. I have been in the commercial real estate management world for 20+ yrs and have never run into that...
-
OOld-tool-guy replied to the thread When Paris started dropping cars.The world was (seemed to be) a much better place back before the internet made everyone an influencer, you could believe most of what...
-
OOld-tool-guy replied to the thread When Paris started dropping cars.Can you back that up with facts?
-
OOld-tool-guy reacted to RunForTheHills's post in the thread Tyre Pressure Guage or yet another new pump with
Like.
This seems like a strange system to me. If you are fixing a flat on the side of the road, you don't need a gauge. Just go by feel. It... -
OOld-tool-guy replied to the thread When Paris started dropping cars.Problem is what to do with the bike when you get to your destination. Take it up to the office? Chain it to a lamp post and hope it’s...
-
OOld-tool-guy replied to the thread Show Us a Tool.Not sure that qualifies as dumb. What were the guide tubes made of? I wouldn't think you could tighten the ties enough to crush the tube.
-
ONot a tool, but tool adjacent: A smart guy who worked for a cabling vendor I used once advised me that when you open a bag of zip ties...
-
OOld-tool-guy replied to the thread Lectric Trike2 750 throttle problem.. The Rover was a bit too tall - we toppled over standing still and at very low speed. We started with Dutch style cruiser bikes, brand...
-
OOld-tool-guy replied to the thread Ebike scam video.What? Did you get a drunk AI to write that?
-
OInteresting video about a guy who thwarts a scam. I don’t know any of the players.
-
OOld-tool-guy replied to the thread Show Us a Tool.A poorly adjusted crescent wrench (adjustable jaw) will slip and round over the nut. A pipe wrench, while unorthodox, will grip like a...
-
OOld-tool-guy replied to the thread Show Us a Tool.Lots of interesting posts here about old wrenches...
-
OOld-tool-guy replied to the thread Show Us a Tool.Can you post a clear picture of the makers marks on the dynamic jaw?