MrCaspan's latest activity

yes they can be removed the picture I showed just had them installed.

I am soldering inside and under a battery tray today. For an extension I would string a section of heat tube down the wires first away...

And if you're not a seasoned solder'r... It's not easy and a crimp connection will probably be much more secure. Make sure they are of...

yeah there's no way I can put more than four or five wires through that hole the width of the wires the whole width of the connector.. I...

Tin the wire first. A very short section only If possible push the wire thru the hole of the terminal to hold it in place. Wrap the...

Actually after measuring these terminal spade width they are about 2.9mm wide so I can use a 2.8mm female spade connector for 14 gauge...

So I got my new terminal block and have no clue how to solder the wire onto it. The wire is 14g but these terminal legs seem really...

That type of failure is common with ebike batteries and it's typically caused by contamination and/or poor vibration isolation.

It's typically over time and progressively gets worse until failure.

And I have no clue if this happened over time or if it all happened at once. I am assuming it was over time. It is a 1000w mid drive so...

No clue, I am guessing there was junk in the port that caused a small disconnect. I didn't take my battery off all summer so it's...

Okay I took my measurements at the bottom of the pins as the top of the pins have some movement This is the male part that is on my...

100% I have a digital caliper and I'll return with details once I get it!

You can have a battery not fully insert and stay on the bike? All of my batteries are designed so they require to be all the way in to...