Recent content by KidWok

I've had about 5-6...all in the city and all sharp debris punctures from nails, staples, glass, etc. Roads are actually cleaner away from the city...I'm also a road cyclists and ride outside of Seattle quite a bit. Nearing 12k miles on the ST1 so probably a similar rate to you. I carry...

Hey all, All the flat tires I've had so far have been on the rear tire. I suspect that is due to the weight of the motor and cargo on the rear rack making it easier for sharp debris to cut through the tire tread and penetrate the casing. A couple of years ago, I tried using Slime tubes and...

Experimenting a bit. I cut up some remnants from zip ties to fill in the full width of the slit just above the dropout. The thickness of a small zip tie is a press fit for the slit. The idea is to fill that gap with some fairly hard material to brace and dampen the vertical load without...

Doh...The torque sensor plate just cracked again. This time JRA. I think it has to do with two things. I use the rear rack to carry things a lot so there is a pretty decent amount of weight bearing down at the frame at the rear dropout. If you look at the TMM4 torque sensor design, you'll...

I had written the last post after I had gotten the replacement controller, installed it, and took it for a short ride to make sure it worked. A few days later, I had my son (110 lbs) on it and we were out for about 25 miles when the controller failed in the exact same way the previous one had...

Hi all! Over a year later...I finally got the Swytch kit and got it working! So I ordered this thing in late June of 2018 and was told it would be delivered later that year. I actually ordered two of them. Time and time again, the company gave me delivery timelines that they failed to meet...

Sorry...I can't help you there. I didn't much care for the FSA parts on my bike so I replaced them. Tai

I'll include some service interval notes on this thread as I'm coming up on three years and 9k miles. I ride my ST1 LE year round in rainy Seattle. It gets used for commuting, towing my kid on a third-wheel bike, towing the Costco run home on an Ikea Sladda trailer. While not entirely a car...

Hey all, My ST1 Limited Edition is coming up on 9k miles as I also am nearing my three year anniversary with it. Did about 4k miles in year one, but got and sold a GoCycle G3 in year two and got a Tern GSD last year that have brought my annual mileage on the ST1 down a bit. I have been...

Nope...and I did use a hand tool to tighten it so just be careful how tight you crank it down! Tai

I had a flat tire a couple weeks ago on my ST1 and it happened to be across the street from a auto repair place. I used their 19mm wrench and air to change my flat tire. As I was tightening the nut back on, I heard a crack. Figured it was just those locking washers seating with each other but...

I used slime in my ST1 LE for awhile. They sealed up a pinprick hole indefinitely, but couldn't handle a small glass induced gash, which made for a big mess. Now using Orange Seal in tubes. So far so good. Needs to have more added every so often, but most reviews say it works very well. Tai

We got an orange one...Seattle is kind of gray in the winter so I wanted something that would stand out. We got the dual battery, Cargo Hold panniers, Sidekick lower deck and two Sidekick cushions, all of which are ready with delivery. We might get the Transporteur front rack when it comes...

Picking mine up any day now! Had hoped to get it Sunday but they found damage when they opened up the box.

Hey all! I'm really excited to build up a Dahon Qix D8 with the yet-to-be-released Swytch system. I have the Dahon being delivered next week and the Swytch likely won't be delivered until late this year. I previously had a GoCycle G3 that didn't quite meet my ideal for a folding e-bike. Am...