Recent content by K1eBikes

Are you not confident with power limitation at low battery SOC%? Would you like to set lower discharge cut off voltage to get more range from your battery? Would you like to remove throttle speed limitation? Theres a new device BB Racing, whit many new functions. You can set Low Voltage cut-off...

Are you not confident with power limitation at low battery SOC%? Would you like to set lower discharge cut off voltage to get more range from your battery? Would you like to remove throttle speed limitation? Theres a new device BB Racing, whit many new functions. You can set Low Voltage cut-off...

M620 owners !!! There is firmware v1.2 (30A) with option to adjust max power at each assistance level! And brand new 750W (25A) firmware v 12.3 which has same options as M560! So including Assistance level % and Acceleration at each PAS. Worth to try. Check K1 Flash page. If you own M510...

Now supported also M620 CAN firmware update. And should be working also with M300 and M420 (same bin file type).

First - do not wap motor (not form left and right side - over bearings water is going inside), display and buttons. ;) Wait for M560, it is sucessor of M600.

M620 definitelly. Or better new M630. It is more then 2 times stronger then Shimano motor for kids. ;)

Dear Bafang fans Would you like to set or tune motor controller parameters? K1 Flash is compatible with all Bafang CAN bus motors (5 pin connector with "house" shape). Also can download motor firmware for M500, M510 and M600 motors and run Calibration. Simple as 1, 2 ,3 ... 1. Insert...

Depends how you take care of that motor. Saw already lot of faults even under 1000km.

Yes, over 120 degree C. You can melt wire insulation or demagnetize neodymium rotor magnets.

There is this abbility for a year now. So far only M510 is supporting it and already saw one Bafang HUB CAN controller which was also able to set power levels. In the near future also M560 and M630 wil suport this. And all Bafang users are waiting for Bafang Go App, where this power levels...

And also second device: K1 BlackBox3. Device which can be cabled permanently on an ebike and you can switch between speed limits any time by holding Plus button. Also to set all other possible parameters. Or you can set controller parameters and deinstall BB3 from ebike. Waterproof and no...

Did you go through the google forms link? There is explained everything. And advantages: - No need to get BESST, passwords to Besst (which expiring), no need to connect to computer and u can flash firmware and set parameters even on a street or during ride when u searching your power setup. -...

Dear Bafang fans Would you like to set or tune motor controller parameters? K1 Flash is compatible with all Bafang CAN bus motors (5 pin connector with "house" shape). Also can update motor firmware for M500, M510, M560, M600, M620 and M820 motors and run rotor Calibration. Simple as 1, 2 ,3...