Recent content by jlw9406

nothin, but for now I’ll wait on a battery, if that doesn’t do it, I’ll pull the rear tire and look at the motor, the controller is in the same compartment as the battery but it does not look the least bit wet or like it’s been wet

Great idea let me try that thanks , batteries fried for sure I opened it up, it’s corroded and rusted across several connections

Anyone know where I can get a 36v 6 or 8ah battery for this scooter, it’s not the typical long square one and all I can find are used on eBay

Can anyone tell me where I can order a new battery for this scooter, I google it but all I see are used on eBay, can I use a 8ah instead of 6ah without harming anything? If so I can replace it with one of those the only diff I see besides the ah Is the replacement will be square (if it will fit...

No it’s 42 steady I wasn’t holding the tester secure enough

Every photo I try and attach is too big but I did find out that when the charger is unplugged it’s light is green and when plugged into the light is red, it is only putting 15v out at the battery, and the volts vary at just the charger plug itself, 42 dropping to 16 but I’m not sure if that’s...

No worries it’s all about learning thanks

I’m befuddled as to why I have 42v at the charger end but only 15v at the other end that plugs into the battery

I’ll send a couple photos in a bit of me testing and where, I really appreciate all the input, hopefully this will also be helpful to someone else at some time

charger light stays green, but I’m not familiar with it I do not know if the light changes color or not, it’s one off Amazon

Battery is out of scooter, base is open and has been for a couple days, I was testing the battery where it plugged into the charging port and was only getting 15v at the plug, battery totally unplugged is only 15 v after being on the new charger 12 hours

Update: The display lights power up but rapidly fade, as the battery only has 15v. I bought a new charger 42v and tested it and it’s putting out 42v, but when I plug it in the scooter and test the lead, it’s only putting out 15v, reckon the wiring from the plug is bad?

The display lights power up but rapidly fade, as the battery only has 15v. I bought a new charger 42v and tested it and it’s putting out 42v, but when I plug it in the scooter and test the lead, it’s only putting out 15v, reckon the wiring from the plug is bad?

Thank you, where would you suggest I access the motor input, at the controller or take the motor out and test that?

Yes under the floorboard, and thanks I’ll start with a new charger to get the battery up to full charge and go from there