GMA52's latest activity

  • GMA52
    GMA52 reacted to Gionnirocket's post in the thread Rear Wheel Removal Tip with Like Like.
    I would not categorize Kenda as low quality. Awards aren't the end all but the tire is respectable...
  • GMA52
    GMA52 reacted to stompandgo's post in the thread Rear Wheel Removal Tip with Like Like.
    Dually e-bike. I like it.
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    Well I would have to fit 2 Swabbe’s side by side on my 4” wheels 🤣🤣
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    So it is not a sealed hump but allows air on both above and below it, correct? Also, am I to assume this is for tubeless mounting?
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    What is that “hump” in the tire. Looks like a partition of some kind
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    Gionirocket, I understand. Good Analogy. I had just read the comparison with Michelin and Kenda for cars and said basically same thing...
  • GMA52
    GMA52 reacted to Gionnirocket's post in the thread Rear Wheel Removal Tip with Like Like.
    I'm tubed 🛞 That's hard to compare as different tread and use play a big part. That said if I had to choose I'd lean Schwalbe It's...
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    Gionirocket, how would you rate Kenda to Schwalbe (not considering the ease of installing) as to ride, issues, etc?
  • GMA52
    GMA52 reacted to PedalUma's post in the thread Rear Wheel Removal Tip with Like Like.
    You can also lay the wheel down at 5 psi and lever the side opposite of the one that is too far in, working the slack around toward the...
  • GMA52
    GMA52 reacted to Gionnirocket's post in the thread Rear Wheel Removal Tip with Like Like.
    I found Kenda reasonably easy... But the easiest by far have been my current Schwalbe Al Grounders 27.5 x 2.6. I didn't need to use...
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    I used soap. I would not do tubeless at this time as I do not have a compressor to provide enough air to force the bead to seal.
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    Is that by squeezing the sidewalls on the outside or pulling on the sidewall. Sorry, I have not done this before (with any success on...
  • GMA52
    GMA52 reacted to PedalUma's post in the thread Rear Wheel Removal Tip with Like Like.
    On fat tires, I will pump to 5 psi. Then check the bead on both sides. If one section is in too far in I pinch the opposite side and...
  • GMA52
    GMA52 reacted to stompandgo's post in the thread Rear Wheel Removal Tip with Like Like.
    Every Kenda tire I've mounted has not been difficult to get onto the rim. I almost always have to use tire pliers to get them to seat...
  • GMA52
    GMA52 replied to the thread Rear Wheel Removal Tip.
    Are the Kenda tires easy to mount? What are the easiest you have used? Maybe not possible for you to state if you are not using 4” wide...
Back