Gionnirocket's latest activity
-
Gionnirocket replied to the thread Suspension Frame: bearing tool (6902 bearing).Ok i think I'm all set. I picked up a cheepó set from Amazon. $36 delivered... -
-
Gionnirocket reacted to 6zfshdb's post in the thread Suspension Frame: bearing tool (6902 bearing) with
Like.
My first thought is to take a caliper gauge to Harbor Freight and check the OD of their sockets. A 3/8" drive socket should be large... -
Gionnirocket replied to the thread Builder gone to the dark side..Ignorance. Learn how to program. You go Don Bafango!
-
My new ride, Bafang BBSHD, then a Bafang, Bafang G62 Fatbike 190mm Bafang G62 Standard Wind (8.0 RPM/V) Rear Hub Motor for 190-195mm...
-
Gionnirocket replied to the thread Suspension Frame: bearing tool (6902 bearing).I guess I'd have to buy it to find out. But now that I think about it... it would need to be just shy of 28mm or it'll get stuck in the...
-
Gionnirocket reacted to RunForTheHills's post in the thread Suspension Frame: bearing tool (6902 bearing) with Like.
Maybe this...
-
Gionnirocket replied to the thread Suspension Frame: bearing tool (6902 bearing).Thanks. Actually the replacements I ended up ordering are 2RS. Couldn't find VRD I don't think I can use the old bearing to push the new...
-
Gionnirocket reacted to Base's post in the thread Suspension Frame: bearing tool (6902 bearing) with Like.
Btw, the VRD is the type of seals in the bearing. In this case a thick rubber seal on both sides. Usually in bike-bearings you'd find...
-
Gionnirocket replied to the thread Suspension Frame: bearing tool (6902 bearing).Yeah gave that a quick try with the sockets on hand and though very close, not close enough for this tight press
-
Gionnirocket reacted to RunForTheHills's post in the thread Suspension Frame: bearing tool (6902 bearing) with Like.
Maybe you can rig one with some threaded rod?
-
Gionnirocket replied to the thread Suspension Frame: bearing tool (6902 bearing).It's going into the rear triangle pivot and it's a very tight fit. Definitely going to need to press this one in.
-
Gionnirocket reacted to Biplaneguy's post in the thread Suspension Frame: bearing tool (6902 bearing) with Like.
Depending on what it's going into, the right size deep socket and a hammer are often all you need. The 6902 is a standard number, but...
-
Gionnirocket posted the thread Suspension Frame: bearing tool (6902 bearing) in General Ebike Discussion.Anyone know of a good quality affordable bearing press tool? Don't need top notch as it'll be for minimal personal use. I'll add...
-
-
Gionnirocket reacted to 6zfshdb's post in the thread Help deciding when to switch to an ebike? with Like.
Just because you ride an e-bike, especially a light weight model, doesn't mean you have to use the assist all the time. Switch it off...
-
Gionnirocket reacted to fooferdoggie's post in the thread What happened? Wesley Willis - Whip the Llama's Ass with Haha.
Make him watch the Melania movie three times without a break.
