Gionnirocket's latest activity
-
Gionnirocket replied to the thread splicing Julet 4 pin tail light cable.My tip with most products like this is to not cut the applicator tip as instructed if it has a screw top and use a pin or small artist... -
Gionnirocket reacted to spokewrench's post in the thread splicing Julet 4 pin tail light cable with
Like.
In August, 2024 I ordered two 50ml bottles of "5210 Solder Multi-material repair adhesive Oil based glue." It turned out to be super... -
Gionnirocket replied to the thread 2015 ejoe Koda battery/motor/ controller question.I'd guess that the motor or controller are bad and that resulted in the battery not being stored properly and dying as well. Hard to...
-
Gionnirocket replied to the thread What have you learned from your e-bike experiences?.I guess he learned that he doesn't like his bike but not how to use the forum 🙃
-
Gionnirocket replied to the thread My "New" Ebike.You may have seen this as it's at the top of a Google...
-
Gionnirocket replied to the thread Servicing the Shimano M360 derailleur..What he said. I've also found that clean is better than lube, especially with quality cables. I've used isopropyl alcohol with...
-
Gionnirocket reacted to stompandgo's post in the thread Servicing the Shimano M360 derailleur. with Like.
Your inner wire and housing are more likely to cause this. A good quality cable set that uses lined housings, coated cables, and cable...
-
Gionnirocket reacted to Slaphappygamer's post in the thread What have you learned from your e-bike experiences? with Like.
Going with a DTC bike, I enabled myself to learn a new hobby. Turns out I really like it and I’m learning quick. After reading horror...
-
It wouldn't be all that difficult to install a new controller and higher voltage battery. It's just that the design is so well...
-
Gionnirocket replied to the thread My "New" Ebike.Seems the original batteries for this bike were 24v nominal. The Satiator bottom rating is 36v, so no go.. But I do believe the current...
-
Gionnirocket replied to the thread My "New" Ebike.Very interesting and looks to be in excellent condition... but do you really want to ride this instead of one of your more modern bikes...
-
Gionnirocket replied to the thread Charging port cover - won't seat.. I put that $hit on everything!
-
-
A touch of dielectric grease did the trick, no cutting required.
-
Gionnirocket replied to the thread splicing Julet 4 pin tail light cable.I would silicone on things like canvas which worked well... but that's also what I had on hand. I try not to buy to many specific...
-
Gionnirocket reacted to PCeBiker's post in the thread splicing Julet 4 pin tail light cable with Like.
I use hot glue, silicone, and shrink tube all the time. I got all three goin on here,.. 😄 BTW, "Maintenance Free" only means that...
