Recent content by FreddyL920

So I found a YouTube video on the controller, and I checked the volt setting. It had jumped from 36v to 48v, ( likely when I had the bike upside down changing a tire). Once I changed it back to 36v it works fine 👍

Good to know...I'll keep that in mind 👍

It's held up well so far...just difficult to get troubleshooting & repair info...and very few shops have a clue.

I believe the specs were 350 watt 36v 10.4Ah...I'd have to check the original description ...

Thanks for your effort. I checked all the connection points.. After searching YouTube I found the solution. Somehow the setting had jumped from 36v to 48v for the display. Once I reset the display ( not a simple off & on) it works fine.. a shame Ancheer does provide more thorough information.

I'm thinking I've got a bad connection, or maybe the display needs to be recalibrating? But I'm guessing. It happened after changing the rear tire, which was a learn as I go project.

I have an Ancheer blue spark 27.5" 350 watt bike. After charging the rear tire I find the battery level on the LCD display is at 1 bar or less, despite battery being fully charged. Any idea how to fix ??

Good point, but the display on the battery itself show full, and I've rode the bike for quite some time for it to be on the last bar. So I believe that the display is faulty or getting a bad reading somehow

I love my Ancheer blue spark. ( I have the 350 watt model) For some reason, the display is only reading 1 bar ( low batter) even when the battery is fully charged. Any ideas how to correct this ?? Thanks Freddy