Recent content by Farshad68

a Stupid question! Pls have a look at this picture. You see the 5 hall sensor wires of my hubmotor. Do these wires go directly to the controller (in my case they do!) or there should be some kind of circuit board inside the motor? Some kind of connection between these and the three phase wires...

The wheel is indeed in the air and without load. If it was the only issue I would take it for a ride and test is but almost nothing works! :)

A pic of the 2nd controller which I guess is an older model. Specifically chose a little bit different as I thought the controller that I already have perhaps is not compatible with my hubmotor. It's a batavus/sparta-ion hub motor and original battery was 24v NiMh

Thanks for fast response. I tried both ways! Disconnecting identification wires before shutting down which immediately stops the motor and after shut down. Shut down only through lcd and disconnecting battery wires. Both same result and motor works only in learning mode. I set the battery to 24v...

Hi I’ve been reading about my issue with ebike controller in past few days and tried everything I could find (different settings through screen, changing PAS wires, using external 3.5v battery between ground and signal wires of throttle etc.) This is a Chinese (brainpower, Aliexpress, ebay ..)...