For sale ST13-50$ or best offer 😛
MASSIVE SALE🌲🎄🛠️🪫
ST7- from 49, 9955
ST5-from 39.99$
ST3-from 29.99$
Good luck to all of you stuck with this elephant🪫🛠️.
all u need is a short piece like 8-20cm of the. CABLE THAT GOES TO THE Battery ; After that is obtained from the bad charger , the rest is easy.. source a proper cable with whatever end con. you want and connect the other part of it to the short cable(+|+, -/-). They have no smart bms this...
in detail this means high quality cells with big capacity for long distance riding or a high discharge rate for those moto ebikers out there...
- and yes a hi quality BMS, a Bluetooth one that will enable the rider to note the temp. of various parameters (T sensors, Mos sensors...)
It would...
well , i know very well what i don't know which is this mid motors in particular😉, but where do they have the TQ sensor located ?
I haven't tried this other ide on my hub motor ebike , but what would happen if one removes the TQ sensor from a mid motor ebike and tries pedalling ? I'm...
Once u engage the pedals and select the PAS mode , the torque translate to to the resistance felt when "rowing "the cranks.
Pas 1 : light resistance, easy rowing🚣♀️
Shouldn't Stromer charge a low 799$ fee for their owners to enable them to change their CA address to a temporary US address ? Seems only the ebikes connected to a canadian address will
be affected.
Optional : 1599$ Platinium permanent address change .
ENABLE PPAC ?
Press yes/yes.
Lupine SL X has IP 68 .
Do either M99's or the OL models have at least IP 65 or higher water protection ? If they do they def. don't show it b/c is not listed on the spec sheet.
Would not want a heavy rain to short the chips on a 400$ light.
Fyi- see the included IP guide for those...
The ONLY OFFICIAL and NASA approved discharge method courtesy of ebiker01:
- power on the Ebike then turn it upside down , engage the PAS /throttle enabled by the user hands ; continue the activity for as long as discharge parameters are met;
- put the ebike back in it's normal upright...