Recent content by bikero

Too long just give me the short answer version: don't gently tap the M6 screw with a plastic hammer, use a normal hammer and apply moderate force until there is no space between the plug (see picture below) and the motor - it helps if you put the bike upside down to see when this happens but you...

Ended up replacing the motor, too difficult to diagnose the exact problem. The new motor cost ~900 euros at the Kerobike dealership in Odorheiu Secuiesc, Romania. Hope I can fix it in the future while I enjoy riding the new motor.

Hi! How did this end? Did you manage to replace the motor? How and what price?

I got it to wiggle a bit but not that much, tapping on the screw doesn't seem to work. The reason why I asked you how the tapping works is that in my case it might be stuck for some reason so I needed a workaround. Really don't understand why a PW-SE is so easy to remove yet a PW-X is so...

Do I have to re-insert the long screws (M8) and torque them to 22 Nm in order for the tapping on the M6 screws to work? Because I initially removed all the screws and only after I read the instructions from the service manual. Also, I don't understand what happens when I tap the M6 screw, how...

Hi Dave! I'm also struggling to remove the drive unit assy. I tapped the bolt with a plastic hammer but nothing seems to happen. How hard did you tap it? Does it have to be a "manly" tap or really a light tap like the instructions say? What happened in your case when you tap it? Did the [a] move?

Hi, Starting with last year I started having motor issues with my 2019 Haibike Sduro Fullnine 8.0. These happened less often before but nowdays they tend to drive me crazy. My e-bike has little over 7000 Km. I had no other issues with the motor, did not have any accidents and my riding style is...

https://www.amazon.co.uk/Yamaha-Electric-Battery-500-Watts-Drive/dp/B0725SDRCH/ Well, a brand new 500Wh Yamaha battery is almost 800 euros. Keeping the proportion per Wh, a 745Wh would be almost 1200 euros. At least for Yamaha, it makes some financial sense. For Bosch or other vendors.. I don't...

What did they write?

I sent them an e-mail with the following questions, will also reply here when (if) they do: 1) Is the increased capacity (ie. 745Wh) only due to the increased battery size or due to a different battery technology than the one used in OEM batteries? 2) Is this battery going to age the same way...

Hi! anybody know what's the purpose of this little screw i the upper battery holder? It can be rotated using a 1.5 allen key and, from what I experimented, when I rotate it clockwhise, the rount plastic cylinder around the screw starts to come down. However, this doesn't make any contact with...

Hi! Two Haibike sduro fullnine 2019 8.0 and 4.0, original chains kmc e10. On the 8.0, chain wear 0.75% in about 900 Km (ridden by me, mostly eco, std on steep slopes, always used the big cogs) On the 4.0, chain wear 0.75% in about 500 Km (ridden by my girlfriend, used a lot of assistance...

Ok, found out that actually there is none but I replaced the rear derailleur shift cable quite easily and got a feeling how it goes. First, I removed the cable inlets and then inserted the cable housing into the top tube and gently pressed it until it reached the end, very close to where the...

Hi! Does anybody know if the haibike 2019 models (ie. sduro, xduro) have easy internal cable routing ie. pre-built routes inside the frame so you can simply insert the cable at one end and it will easily find its way at the other end.

Hi guys! I'm starting to notice an interesting fact about the Yamaha PW-X motor (I have a haibike fullnine 8.0 2019). Let's say I start a steep climb so I'm in my second lowest gear in the back, small chainring in the front. I switch from what I typically use all the time, eco, to std. At some...