Recent content by amradio

Thanks. I'll play around with them.

I like the color display. No issues seeing it and it looks better. Can you explain this C4 setting to me? I went riding in the mountains yesterday and having C5 at 10 was no good. The power was so much I couldn't not keep the front tire on the ground and therefore couldn't turn, (climbing hills...

Both versions were the fancy colored one. The replacement had a USB port on the back.

It ended up being the LCD8H display. For some reason it just died. The retailer I bought it from sent out a replacement and I'm up and running again. The old display was an LCD8H and the new one is an LCD8HU. It has a USB port on the back.

Well, this controller with the Bafang G062 is amazing. It climbs hills with ease. I have only gotten about 10km on the bike as I was away for some time. I took the bike out yesterday and was riding on some hills. Then I was riding on a paved road and all of the sudden I lost all power and my...

I reset the display. C10. Selected Y and shut it off. Turned the display on and put in my settings I had, and I had the same issue. Pulled out my log book of each entry change I've done already and I started over. Left P1 at 100. Started P2 with 6, then 5 and walked my way down to 1. Now with 1...

This is exactly what is so confusing. Why does the speedometer work correctly when using throttle or pedaling, but when coasting it drops off to 4 to 6 km/hr. Makes no sense.

Here are my current settings. You can see from the Bafang spec sheet, P1 should be 100 and P2 should be 6. I tried changing P3. On setting 1 or 0, same speedometer results Changed C2 to 1. Nothing works. No power at all to motor. Changed back to 0. C1 - settings 1 and 2 work the best for pedal...

Thanks everyone. I will try these suggestions today and post back later with my findings.

From the manual "P1 = motor gear reduction ratio× number of motor magnet pieces". It says magnet pieces, not pairs. I can try 50, but I tried 87 and that made the speedometer very messed up. At 100, the speedometer is accurate while pedaling or using throttle. Also, P3 is either 1 or 0. Those...

Changing P2 to 1 causes the speedometer to be very slow to respond and the speed still drops off when coasting. Can you explain how the external speed sensor works? Will settings need to be changed in the display? How would the external sensor take control or precedence over the original...

The Bafang G062 is a 1000 watt motor. It should say G062 on the hub if it is.

I have a KT 45A controller (sine wave) and LCD8H display. When I pedal or use the throttle, the speedometer works properly and shows the correct speed. As soon as I stop pedaling or using the the throttle, the speedometer drops to about 4 to 6 km/hr. (it doesn't matter what my actual speed it...

I bought a KT 45A controller and the LCD8H display for the KT controller. Does anyone have all the settings they have used? I see there are some P settings and C settings, and all the research I've done seems to show settings for other bikes, or not a G062. I need help with P5 (52 volt...

I don't know anything about the Eunorau. I've had the Blade 2 since they first released, as does my buddy. We both ride them hard and have had no issues. We have the upgraded torque washers from Rize. The 1000 watt is just a rating Rize used. They claim their controller is 27A peak, so 1404...