Recent content by AdamC

I don't do electronics!!!! which is hilarious since I do ebikes....... but there is a guy on endless sphere who sells a voltage pas kit for brushed motors...

do you need a limo license for that thing?!!!!!!!!

I'm kinda leaning towards the combination of pas sensor and throttle. run the pas like a cruise control and throttle good for the hills and quick starts.....but right now only have a throttle, likely to add PAS in the near future

there are actual cutoff sensors you can get to add to your current brakes

finally got some photos of completed bike- nicknamed black &decker

The motor drive chain dropped off twice die to the idler pulley that the kit came with- really bad design. but there was just enough play to remove a link and install a half link. now I have good tesion without the pulley- I email the seller to sugget it as part of the kit- p.s. I really will...

maiden voyage! 13 miles 50 minutes with 1100 feel climbing yesterday 17 mile morning commute with 1500 feet of climbing in 1hr 10minutes losing the Schwalbe marathons plus tires, too much drag for such a long commute. so far thrilled with the kit, and the bike I got from the co-op is supremely...

I replaced the freewheel and it resolved the problem, today i will do a hilly ride and see what my range is looking like. I,ll post a photo as well

Everything is done , the freewheel seems to be skipping under human power as well as epower, will try a different freewheel and hopefully that solves my problems. the chain is new. otherwise when its not skipping the motor pulls well uphill, the supplied headlight is bright and the motor noise...

No it seems like pretty thick material around an 1/8 in thick. inexpensive steel but stout enough I would believe

I took it for a very short test run this weekend. pulls hard up a short steep hill by my house and not very load at all. I need to replace the old chain that came on the bike from the bike co-op and attach the rear brakes. both come in today. so far it seems like a decent kit especially for the...

I have everything wired up and everything seems to work. need to get pedals on and brakes hooked up and everything all cleaned up before its ready for a test ride. I wil post pics and maybe a video when she is finished

225 plus shipping

Email received from seller- its on its way- it is a 30 amp controller the battery I have on order is continuous 25ah with peak of 50. I think that should pair well , I am thinking a bit f a buffer to prevent over heating. But electronics is witch craft so who knows,

Yeah its hard to gauge with only 1 review but seems like a pretty basic peice of kit. I oike the simplicity i would prefer a thumb throttle but like the display on the twist throttle ... its trade off. Thanks for the video link!